Cisco WLC to get AP Info via SSH
It will take 1.2 seconds to run the following commands:
- show ap config 802.11a summary
- show ap config 802.11b summary
- show advanced 802.11a summary
- show advanced 802.11b summary
- show advanced 802.11a txpower
- show advanced 802.11b txpower
- show mesh neigh summary all
- show client summary ip
- show client summary
- show ap gps location summary
3D-P Hornet via SSH
It will take 5.3 seconds to run the following commands (including the 5 second tcpdump)
- ifconfig
- iwconfig
- wpa_cli scan_result
- cat /etc/hostname
- timeout 5 tcpdump (specific filter condition for things like GPS corrections and AMP messages)
- ohiwhereami
CISCO WGB via SNMP
It will take 0.4 seconds to make the following requests (note the long OIDs are built from SSID + next hop MAC learned from other OIDs and so will change from device to device).
- GetRequest .1.3.6.1.4.1.9.9.273.1.1.1.0
- GetRequest .1.3.6.1.4.1.9.9.272.1.1.1.6.1.2.1.1
- GetNextRequest .1.3.6.1.4.1.9.9.273.1.3.1.1.1
- GetRequest .1.3.6.1.4.1.9.9.273.1.3.1.1.3.1.16.109.105.110.101.115.116.97.114.45.99.111.109.109.97.11 0.100.228.170.93.165.137.97
- GetRequest .1.3.6.1.4.1.9.9.273.1.3.1.1.4.1.16.109.105.110.101.115.116.97.114.45.99.111.109.109.97.11 0.100.228.170.93.165.137.97
- GetRequest .1.3.6.1.4.1.9.9.273.1.3.1.1.1.1.16.109.105.110.101.115.116.97.114.45.99.111.109.109.97.11 0.100.228.170.93.165.137.97
- GetRequest .1.3.6.1.4.1.9.9.273.1.3.1.1.7.1.16.109.105.110.101.115.116.97.114.45.99.111.109.109.97.11 0.100.228.170.93.165.137.97
- GetRequest .1.3.6.1.4.1.9.9.273.1.3.1.1.9.1.16.109.105.110.101.115.116.97.114.45.99.111.109.109.97.11 0.100.228.170.93.165.137.97
- GetRequest .1.3.6.1.2.1.2.2.1.6.1
- GetRequest .1.3.6.1.2.1.1.5.0